Garden Hose Foam Gun

• Transforms Liquid Soap into a Foamy Wash
• Speeds Up Cleaning Process 
• Attaches to any Standard Garden Hose 
• Made With Durable Plastic and High Quality Brass Fittings 
• Adjustable Dial for Increasing or Decreasing Soap Ratio

 

The quickness and ease of use with the Garden Hose Foam Gun combined with our concentrated cleaners maximizes coverage and drastically reduces clean up time. Here at Slick Products our cleaners and wash products were developed by off-road enthusiasts for off-road enthusiasts to be non-corrosive and provide the fastest, safest cleaning experience available.

If using a bucket or garden sprayer follow mixing ratio above. Makes up to 1 Gallon of ready-to-use solution. Results may vary with non-recommended applications. Unused mixed product may be stored in safe place for future washes.

Garden Hose Foam Gun requires pre-mixing ratio in holding tank. Liquid will then be diluted again when foam is applied. Makes up to 1 Gallon of product per fill. Unused product product may remain in tank for future washes.

Pressure Washer Foam Gun requires pre-mixing ratio in holding tank. Liquid will then be diluted again when foam is applied. Makes up to 1 Gallon of product per fill. Unused product product may remain in tank for future washes.

  • Step 1

    Before application, scrape off areas with extra thick mud or pre-rinse with water. Dilute the concentrated Off-Road Wash to the proper ratio shown above or on the back of the bottle. Using a garden sprayer or foam gun, fully saturate dirty and muddy surfaces. Allow the wash to soak for 3-5 minutes without drying up. Keep the surface moist by misting with water. For best results agitate with soft bristle brush.

  • Step 2

    While the Off-road Wash is soaking, use the Multi-Purpose Cleaner & Degreaser to target greasy spots and areas with nasty grime or film residue. Apply a few squirts or as needed and agitate with a soft bristle brush. After 3-5 minutes has passed from initial application of Off-Road Wash, rinse the entire vehicle with a pressurized water source. (For best results use a pressurized nozzle on garden hose or pressure washer.)

  • Step 3

    After rinsing, use a microfiber towel to wipe down and dry all the surfaces. Apply the Multi-Surface Shine & Protectant to plastic, rubber, and vinyl surfaces. Hold can approximately 6-8 inches away, spray an even layer to coat the surfaces. Allow the product to sit for a few minutes before buffing, or leave for a wet look. (Do not apply to tire treads, seat, or areas that should not become slippery.)

Customer Reviews

Based on 5 reviews Write a review

Related Items