Off-Road Wash

ADD A FOAM GUN! Recommended for a faster cleaning experience.
Pressure Washer Foam Gun Pressure Washer Foam Gun $39.99
Garden Hose Foam Gun Garden Hose Foam Gun $39.99

• Super Concentrated Motorsport Cleaning Solution
• Formulated to Be Safe on Paint, Plastics, and Metal Surfaces
• Quickly Removes Heavy Dirt and Mud
• Maintains Lubrication on Bearings and Chassis
• Preserve the Life, Look, and Value of Your Vehicle



Slick Products Off-Road Wash is a super concentrated cleaning solution designed to remove heavy dirt and mud without stripping lubrication from bearings or pivot points.

If using a bucket or garden sprayer follow mixing ratio above. Makes up to 1 Gallon of ready-to-use solution. Results may vary with non-recommended applications. Unused mixed product may be stored in safe place for future washes.

Garden Hose Foam Gun requires pre-mixing ratio in holding tank. Liquid will then be diluted again when foam is applied. Makes up to 1 Gallon of product per fill. Unused product product may remain in tank for future washes.

Pressure Washer Foam Gun requires pre-mixing ratio in holding tank. Liquid will then be diluted again when foam is applied. Makes up to 1 Gallon of product per fill. Unused product product may remain in tank for future washes.

  • Step 1

    Before application, scrape off areas with extra thick mud or pre-rinse with water. Dilute the concentrated Off-Road Wash to the proper ratio shown above or on the back of the bottle. Using a garden sprayer or foam gun, fully saturate dirty and muddy surfaces. Allow the wash to soak for 3-5 minutes without drying up. Keep the surface moist by misting with water. For best results agitate with soft bristle brush.

  • Step 2

    While the Off-road Wash is soaking, use the Multi-Purpose Cleaner & Degreaser to target greasy spots and areas with nasty grime or film residue. Apply a few squirts or as needed and agitate with a soft bristle brush. After 3-5 minutes has passed from initial application of Off-Road Wash, rinse the entire vehicle with a pressurized water source. (For best results use a pressurized nozzle on garden hose or pressure washer.)

  • Step 3

    After rinsing, use a microfiber towel to wipe down and dry all the surfaces. Apply the Multi-Surface Shine & Protectant to plastic, rubber, and vinyl surfaces. Hold can approximately 6-8 inches away, spray an even layer to coat the surfaces. Allow the product to sit for a few minutes before buffing, or leave for a wet look. (Do not apply to tire treads, seat, or areas that should not become slippery.)

Customer Reviews

Based on 23 reviews Write a review

Related Items